Hello,
We have a Deckel FP3A with Heidenhain TNC 320 Control. The machine was working fine since 1986, but last year some electronic problems started. First the X axis control card failed, we looked for a second hand card and we replaced it. This works for three months, but now the control has lost the machine parameters. The original information was printed and we have lost those pappers. Either we don't have any floppy disk.
So, we would appreciate if someone could provide these parameters, in order to start again the machine.
Thanks
We have a Deckel FP3A with Heidenhain TNC 320 Control. The machine was working fine since 1986, but last year some electronic problems started. First the X axis control card failed, we looked for a second hand card and we replaced it. This works for three months, but now the control has lost the machine parameters. The original information was printed and we have lost those pappers. Either we don't have any floppy disk.
So, we would appreciate if someone could provide these parameters, in order to start again the machine.
Thanks