Hi. I know that much has been written about this, but I can not find exactly what I'm looking for.
I have a problem with my vertical spindle that's the way i have switched all needle bearing and thrust bearing I bought stock of a bering dealer. I measured both inside and out the measurements. according to him, one would do it to determine the size of needle berings this would then be right. The name of Needel Berings I bought is called K 50x57x18 Ina and K45x52x18.
uses grease NBU15
The problem is that the spindle gets hot. It became hot even with those old berings. That's why I switched Berings thought these were the problem.
How hot should Spindle and Vertical head be?
Anyone who has any ideas?[ATTACH=CONFIG]222625
best regards
I have a problem with my vertical spindle that's the way i have switched all needle bearing and thrust bearing I bought stock of a bering dealer. I measured both inside and out the measurements. according to him, one would do it to determine the size of needle berings this would then be right. The name of Needel Berings I bought is called K 50x57x18 Ina and K45x52x18.
uses grease NBU15
The problem is that the spindle gets hot. It became hot even with those old berings. That's why I switched Berings thought these were the problem.
How hot should Spindle and Vertical head be?
Anyone who has any ideas?[ATTACH=CONFIG]222625
best regards