Last days, I 've been trying to re-organise the workshop, and put some order in the stuff travelling between the workbenches and floor, and managed to "steal" some nice wooden crates from a friend...
I had to use some of them for the FP3NC and KF12 accessories, so they needed some appropriate modification...:D, to fit with the environment
![Click image for larger version.
Name: 2013-05-21 16.32.10.jpg
Views: 97
Size: 85.9 KB
ID: 77176]()
The logo's dimensions are aproxx 180x25(mm)
I used a 3mm carbide endmill without compensation (so its not as "edgy" as the original)
Depth is 2mm (but I believe you can go deeper via part repetition)
There are many points in the process, so it might get a bit annoying with all these moves(slower feedrate is a solution)
Zero point is aprox between the "C" claws...
Unfortunately, I had to split the code into pieces, to upload...(better check it first graphically)
Hope some of you guys, might find it interesting....:scratchchin:
I had to use some of them for the FP3NC and KF12 accessories, so they needed some appropriate modification...:D, to fit with the environment
The logo's dimensions are aproxx 180x25(mm)
I used a 3mm carbide endmill without compensation (so its not as "edgy" as the original)
Depth is 2mm (but I believe you can go deeper via part repetition)
There are many points in the process, so it might get a bit annoying with all these moves(slower feedrate is a solution)
Zero point is aprox between the "C" claws...
Unfortunately, I had to split the code into pieces, to upload...(better check it first graphically)
Hope some of you guys, might find it interesting....:scratchchin: