Hi
I have a Infratirea FUS-22 built April 1975 in Oradea, Romania.
The manual lists:
My questions are:
ISO15 is thinner than ISO68, but I figure if it is OK for my Nardini lathe, it should be OK for the mill. Comments??
What are modern equivalents of FP 3 and the Mobil AA greases? I am thinking that almost any modern Grade 3 will be OK.
What is commonly used to pump the oil into all of the grease nipples? It looks like I need to get an oil gun and swap the coupler for one off a grease gun.
Dazz
I have a Infratirea FUS-22 built April 1975 in Oradea, Romania.
The manual lists:
- Tellus Oil 33, ISO68 (I already have a bucket of this for my lathe)
- Tellus Oil 15, ISO 15 for the gear boxes
- Alvania Fett3 or Grease FP 3
- Mobil grease AA No.3
My questions are:
ISO15 is thinner than ISO68, but I figure if it is OK for my Nardini lathe, it should be OK for the mill. Comments??
What are modern equivalents of FP 3 and the Mobil AA greases? I am thinking that almost any modern Grade 3 will be OK.
What is commonly used to pump the oil into all of the grease nipples? It looks like I need to get an oil gun and swap the coupler for one off a grease gun.
Dazz