After some practicing/familiarising with my FP3nc, I decided to do some maintenance around, like changing the oil, cleaning the bedways, bellows etc....
Can anybody tell me the exact amount of oil to pour in the vertical spindle(3150rpm), 'cause the referring page is missing from my manual?
I read in some older posts, that the z-axis noise is probably due to dirt on the servomotor brushes....Is this up to date? I am going to clean them tommorow...
However, my major concern is another noise...I have been hearing it since i first used the fp3, but waited to be sure that is not something temporary...
The gearbox sounds problematic (gear problem?) in the following speeds 50-100-200-400-800-1600-3150...Do these speeds have something common?(gear,shaft):scratchchin:
Thanks in advance
Can anybody tell me the exact amount of oil to pour in the vertical spindle(3150rpm), 'cause the referring page is missing from my manual?
I read in some older posts, that the z-axis noise is probably due to dirt on the servomotor brushes....Is this up to date? I am going to clean them tommorow...
However, my major concern is another noise...I have been hearing it since i first used the fp3, but waited to be sure that is not something temporary...
The gearbox sounds problematic (gear problem?) in the following speeds 50-100-200-400-800-1600-3150...Do these speeds have something common?(gear,shaft):scratchchin:
Thanks in advance