Moving our "new" Deckel FP2NC

Hi all

My first post here.

My son and I are about to move the recently purchased FP2NC int our workshop. All has to go down a hole (access hatch) of 1020 x 1250 mm hole. To make it worse, the hole can be accessed through a garage, that has only 2140 mm height. The door is even less.
I have installed a hoist attachment point that can handle up to 2000 kg. We have a suitable chain lift (2000kg, some hand winches (900 kg), lifting belts of various lengths, all 3000 kg, ratchet straps, a workshop crane (max 2000 kg) and a pallet trolley.

The parts that need to go down the hole are:

Main machine, with following part dismounted:
- "Flip head":
  - I think the cable on top of the spindle is the power to the spindle motor, am I right?
  - I think, removing the flip head should not be too complicated. Just secure it by crane, remove the screws, the guide behind the flip head and it should come off. Am I right?
  - splash cabinet, should come off downwards from the table
  - standard table, secure by crane, remove screws and we should be done
  - handles to manual wheels or wheels as a hole
  - x-axis motor, previous owner has done it before and will help, so should be not a big deal
  - We might have to till the machine by some 30 to max 45°. Will this cause any problem (oil baths?)?
- complete dialog 4 control system
  - Seems to be a major PITA
  - There are connectors in the electro cabinet, but none on the machine.
  - has anyone done it before?
electro cabinet, I guess, should not be a big issue, as there are connectors