H al'!!
The machine itself doesnt know when it has the probe in the spindle. As a result it will spin the probe up to max rpm, move at full rapid and potentially try to machine with it, if the operator isnt aware of what is going on.
In the Tool Table the tool PLC ID shows %00010010 however we believe this is incorrect.
Are you able to help with the correct number to make that machine recognise there is a probe? Or point me in the right direction?
Many thank
Sam
Machine
2007 DMC 835V Deckel Maho.
ITNC i530 controller
NC software : 340491 03 SP3
PLC : 4B0000_HEDR_00B
10k Spindle
Probe: Heidenhain TS640
The machine itself doesnt know when it has the probe in the spindle. As a result it will spin the probe up to max rpm, move at full rapid and potentially try to machine with it, if the operator isnt aware of what is going on.
In the Tool Table the tool PLC ID shows %00010010 however we believe this is incorrect.
Are you able to help with the correct number to make that machine recognise there is a probe? Or point me in the right direction?
Many thank
Sam
Machine
2007 DMC 835V Deckel Maho.
ITNC i530 controller
NC software : 340491 03 SP3
PLC : 4B0000_HEDR_00B
10k Spindle
Probe: Heidenhain TS640