I picked up an FP1 yesterday. All working great, no visible wear on the ways, (except the coolant pump that is noisy and wont pump the cutting oil that was still in the sump). It came with a set of decker branded collets and the MT4 adapter for the smaller decker collets.
However, it didn't have the lower half of the tilting table, just the top. It did come with the tilting dividing head. Im going to make another pass at the location at some point, but Im pretty sure the place chucked that part at some point.
Wondering if anyone with a tilting table wants to trade for the tilting indexer? Its got a set of three plates and the angle division plate, as well as a chuck adapter. Ive got dividing heads up the yahoo and a DMU50V so not much call for manual dividing heads here.
However, it didn't have the lower half of the tilting table, just the top. It did come with the tilting dividing head. Im going to make another pass at the location at some point, but Im pretty sure the place chucked that part at some point.
Wondering if anyone with a tilting table wants to trade for the tilting indexer? Its got a set of three plates and the angle division plate, as well as a chuck adapter. Ive got dividing heads up the yahoo and a DMU50V so not much call for manual dividing heads here.