Deckel PLC program for Heidenhain control wanted

I realize this is an extreme long shot, but, I'm hoping some kind soul out there would be willing to share their PLC program with a total stranger. I'm looking for something that was optimized for any of the Deckel mills set up with any of the Heidenhain controls. Ideal would be the binary file but even an ASCII text file would be very appreciated. Even just a photo of a printout would be very useful. I have a couple of PLC programs now but nothing specifically for Deckel. One is the "Standard" version that normally shipped with the TNC 355 unless otherwise specified, and the other is labeled "TRIAX2" for the TNC360C. I also have a TNC 306 "Standard" but that is for an EDM.

The ASCII files I have now are attached below, for the curious minded to peruse.

TNC 306 PLC Standard.txt
TNC 360C PLC TRIAX2.txt
TNC 355 PLC Standard-pt1of2.txt
TNC 355 PLC Standard-pt2of2.txt

Dan

Attached Files

• TNC 306 PLC Standard.txt (17.7 KB)
• TNC 360C PLC TRIAX2.txt (12.5 KB)
• TNC 355 PLC Standard-pt1of2.txt (12.7 KB)
• TNC 355 PLC Standard-pt2of2.txt (12.2 KB)