Hi there,
Recently i bought an FP5NC. After first power up I got an error on the NSP52.. swapped that one, looks good..
However I cannot control the axes at all. There was some (physical) drift/runoff (tuned the bosch controller), so power electronics looks good.. Tool change and spindle work OK. I also have both green lights and no red lights on the NPP card (SPS) in the electrical cabinet..
Very strange! Any thoughts? This week I might swap some cards (NPP90?) of the dialog 4 control with a friend.
Cheers Henk
Recently i bought an FP5NC. After first power up I got an error on the NSP52.. swapped that one, looks good..
However I cannot control the axes at all. There was some (physical) drift/runoff (tuned the bosch controller), so power electronics looks good.. Tool change and spindle work OK. I also have both green lights and no red lights on the NPP card (SPS) in the electrical cabinet..
Very strange! Any thoughts? This week I might swap some cards (NPP90?) of the dialog 4 control with a friend.
Cheers Henk