I have a few random questions about my fp2NC:
How does length compensation input work? If I type D as part of a block it is ignored.
Where is the spindle gearbox oil filler?
When the machine is in inch mode, are feeds still mm/min?
What is a good solution for a coolant return hose that doesn't kink? I don't have a lot of room in my shop, so the coolant reservoir is tucked back into the base of the mill, but the hose kinks flat since there is a 180 degree bend. The manual says "attach coolant reservoir to machine as described in information leaflet JF 728". Anyone have a copy of that?
I need to order a new Z axis wiper from FPS. Is there anything else that I should probably order at the same time, that ought to get replaced on a regular basis to protect the ways or keep the machine operating properly?
One of the sliding doors from the enclosure keeps coming apart at the top. I've repaired it twice by using plexiglass solvent (glue), but the surface is rough and the blocks don't hold long. Any suggestions?
-Dave
How does length compensation input work? If I type D as part of a block it is ignored.
Where is the spindle gearbox oil filler?
When the machine is in inch mode, are feeds still mm/min?
What is a good solution for a coolant return hose that doesn't kink? I don't have a lot of room in my shop, so the coolant reservoir is tucked back into the base of the mill, but the hose kinks flat since there is a 180 degree bend. The manual says "attach coolant reservoir to machine as described in information leaflet JF 728". Anyone have a copy of that?
I need to order a new Z axis wiper from FPS. Is there anything else that I should probably order at the same time, that ought to get replaced on a regular basis to protect the ways or keep the machine operating properly?
One of the sliding doors from the enclosure keeps coming apart at the top. I've repaired it twice by using plexiglass solvent (glue), but the surface is rough and the blocks don't hold long. Any suggestions?
-Dave