I have tried to make this thread title detailed enough to be easily found in a search........... Because I've tried.
Trying to get to the bottom of Tool Compensation and Compensation on Contour in Dialog3.
The manual I have talks about storing length comps in chapter 6 (pg.6-28) as well as contour radius compensation on pg 6-31.
Chapter 7 shows how to enter the comp values. Each tool location will only accept one compensation value, but the manual comments on pg.7-9 to remember to only use positive values for radius compensation on contour.
Are the length and radius compensation values for a single tool stored as two different locations? e.g. D5 would store +1.1mm (length) and D55 would store +2.5mm (radius)
Can anyone detail just how one can use both length and radius compensation in Dialog3.
Trying to get to the bottom of Tool Compensation and Compensation on Contour in Dialog3.
The manual I have talks about storing length comps in chapter 6 (pg.6-28) as well as contour radius compensation on pg 6-31.
Chapter 7 shows how to enter the comp values. Each tool location will only accept one compensation value, but the manual comments on pg.7-9 to remember to only use positive values for radius compensation on contour.
Are the length and radius compensation values for a single tool stored as two different locations? e.g. D5 would store +1.1mm (length) and D55 would store +2.5mm (radius)
Can anyone detail just how one can use both length and radius compensation in Dialog3.