My fp2NC D2 stopped mid-program with error 08. The manual describes the fault as an error in X axis position control and lists several possible causes. I restarted the machine, re-zeroed and re-ran the same program, no problems encountered. Any ideas what the most likely causes are? I haven't serviced the X-axis scale, perhaps that is the most likely cause? This is the second time this fault has occurred in the last three months or so.
One of the causes listed is fault in drive amplifier, drift error. I always see some movement away from program zero as the machine warms up, and need to re-zero, maybe every couple of hours, is that possibly related?
-Dave
One of the causes listed is fault in drive amplifier, drift error. I always see some movement away from program zero as the machine warms up, and need to re-zero, maybe every couple of hours, is that possibly related?
-Dave