Hi
We got this mill about 6 months ago and I finally had a chance this week to set it up.
![]()
The mill is wire to 240 three phase and has the factory boost transformer. I used the +% taps to get a final voltage of ~389. I do not have the manuals or flip cards but am working to get the cards and manuals. Everything that I have tried so far has worked all speeds, tool changer, CRT, lube, spindle lock and DRO. I have the control set on 1 for manual mode. The DRO is now in mm but I would like to switch it to inch, how do you do that? How do you zero the DRO? I'm sure this mill will need new batteries, what problems should I expect to see until they are changed? Where is the best place to check to see that it is getting lube (I can hear it and the light comes on)? Any help with the manuals would be great.
Andy
We got this mill about 6 months ago and I finally had a chance this week to set it up.
The mill is wire to 240 three phase and has the factory boost transformer. I used the +% taps to get a final voltage of ~389. I do not have the manuals or flip cards but am working to get the cards and manuals. Everything that I have tried so far has worked all speeds, tool changer, CRT, lube, spindle lock and DRO. I have the control set on 1 for manual mode. The DRO is now in mm but I would like to switch it to inch, how do you do that? How do you zero the DRO? I'm sure this mill will need new batteries, what problems should I expect to see until they are changed? Where is the best place to check to see that it is getting lube (I can hear it and the light comes on)? Any help with the manuals would be great.
Andy