cost a fortune to ship to the USA even though it wouldn't weigh much ? (due to physical dimensions and maybe the need of a full crate)
Ideally the type that fit the bottom for an FP2 or 3...but I would consider the type that mount to the X slde (like at link very bottom of this post) and even an FP1 bottom type version would work if used and cheap enough.
email me at procyon@hargray.com if you have one to sell.
-----------------------------------------------------
Ironically I have a sheet metal guy in town that can make one for amazingly low dollar, and did a great job on the one he did... but he has to have an already existing one to go by...which I had then, but not now... if only I had had the foresight to have him make two of them !
http://www.practicalmachinist.com/vb...light=chip+pan
Ideally the type that fit the bottom for an FP2 or 3...but I would consider the type that mount to the X slde (like at link very bottom of this post) and even an FP1 bottom type version would work if used and cheap enough.
email me at procyon@hargray.com if you have one to sell.
-----------------------------------------------------
Ironically I have a sheet metal guy in town that can make one for amazingly low dollar, and did a great job on the one he did... but he has to have an already existing one to go by...which I had then, but not now... if only I had had the foresight to have him make two of them !
http://www.practicalmachinist.com/vb...light=chip+pan