Hello to all.
I am new in this forum, but I reading it many years.
In a week or two I get to my home a universal milling machine Deckel FP4MA with Contour 2 controller. I read all post in search, but nobody have write what is possible to make in practice with cycle programming (not with CAM and data transfering program).
Is there option to mill a dowel slot in some shaft?
Is cycle could be make for two tools, one roug miller and one fine mill?
Please someone if have this machine give me some advice.
I need machine for not complicated parts for maintenance :)
Is there any manual for programing Contour 2 in English witch is possible to buy?
Best regards to all, and thanks for help, and sory for bad english :nutter:
I am new in this forum, but I reading it many years.
In a week or two I get to my home a universal milling machine Deckel FP4MA with Contour 2 controller. I read all post in search, but nobody have write what is possible to make in practice with cycle programming (not with CAM and data transfering program).
Is there option to mill a dowel slot in some shaft?
Is cycle could be make for two tools, one roug miller and one fine mill?
Please someone if have this machine give me some advice.
I need machine for not complicated parts for maintenance :)
Is there any manual for programing Contour 2 in English witch is possible to buy?
Best regards to all, and thanks for help, and sory for bad english :nutter: