I am going to mount a Makita trim router to the quill of my Deckel FP4NC and am looking for opinions on my design. I will be using this spindle for machining wood with mostly 1/8" shank end mills down to 1/64" dia. I will be fabricating the mount out of 1" ALUM plate and using 1/4" cap screws to clamp mount to the quill and router. Here is a pic of my design, it is as basic as I think it could be.
Also if I clamp onto the quill how repeatable do you think the spindle location will be if I extend the quill in and out?
Also if I clamp onto the quill how repeatable do you think the spindle location will be if I extend the quill in and out?