I have a FP4MA with contour 2 control. The machine is 2.5D so the Y and Z axis are driven by the same servo which is mechanically switched between the two axis.
My problem is that I recieved the mill with the Z axis resting on the limit switch which causes the control not to respond. What I find strange is that the handwheel for moving the Z axis is also disconnected so I can not manually move the table off the switch.
I am probably just missing some simple proceedure for getting the machine moving, can anyone help me out ?
Thank you in advance
My problem is that I recieved the mill with the Z axis resting on the limit switch which causes the control not to respond. What I find strange is that the handwheel for moving the Z axis is also disconnected so I can not manually move the table off the switch.
I am probably just missing some simple proceedure for getting the machine moving, can anyone help me out ?
Thank you in advance